
Sleepbuds Overview

Sleepbuds
Sleepbuds® are designed to comfortably block out sleep-disrupting sounds and replace the noise with anything you’d like to stream. They come with all-night battery, audio streaming, science-backed sleep sounds, & biometric sensing.
To keep your Sleepbuds super tiny, they use Bluetooth Low Energy (BLE) technology to connect directly to your Smart Case. Your Smart Case then connects to your phone or tablet for control in the Ozlo App and audio streaming over Bluetooth Classic. The Smart Case also houses a number of sensors so you can keep track of your sleeping environment (coming soon!).

Charging Pads
When placing your Sleepbuds into the Smart Case make sure the charging pads make solid contact with the base of the charging pins on the Smart Case in order to charge.

Silicone Tips
Sleepbuds come with 4 differest size Silicone tips to ensure a proper fit. Each tip will have a corresponding number printed on them to make sure the proper size is used. Each size will also have a L and R printed on them to make sure each side matches the correct Sleepbud.
0 — Extra Small
1 – Small
2 — Medium
3 — Large

Smart Case
The Smart Case Lid acts as a power switch to power on and off your Sleepbuds when the Sleepbuds are inside the case. Close the lid of the Smart Case with Sleepbuds inside to charge.The Smart Case also features:
- Bluetooth connection to phone/tablet.
- Bluetooth Low Energy (BLE) connection to the Sleepbuds.
- Temperature sensor for room temperature tracking.
- Microphone for environmental noise tracking.

Charging Pins
The Smart Case charging pins provide charging power to the Sleepbuds. The Sleepbud charging pads must be correctly placed and seated on the charging pins in the Smart Case in order to charge.

Smart Case Lights
The 5 dot lights in the center of the case are used to communicate connecting, connected, charging, charge, pairing mode and updating states of the case.
Sleepbud Lights
The right and left long lights are used to communicate connecting, connected, charging, and charged states of the Sleepbuds.

Smart Case Lid
The Smart Case lid acts as a power switch for your Sleepbuds when they are correctly seated inside the case. Close the lid to turn your Sleepbuds off. Open the lid to wake them up.
When your first open the lid to wake up your Sleepbuds, please wait till your Sleepbuds lights turn on. Once both Sleepbud lights turn on, they are ready to remove from the case. This should only take a few seconds.
Your Smart Case will reboot 30 seconds after you close the lid with the Sleepbuds charging inside. This ensures that you have a fresh start each time you use your Sleepbuds.

USB Charging Port Light
Located on back of case, the USB Charging Port Light glows faintly green when your Smart Case is plugged in, getting power, and charging.

Factory Reset Button
Located on back of Smart Case to the left of your USB Charging Port, the Factory Reset button is used to completely reset your Smart Case and Sleepbuds. It will remove all previously paired devices, resetting all settings to what was defined at the factory, and renaming the product to "Ozlo Sleepbuds". Insert a thin paper clip into the hole and press until you feel a click.

USB Charging Cable
The supplied USB Charging Cable uses a Standard USB A to USB C connector. The USB C side of the cable plugs into the back of the Smart Case. The larger USB A side of the cable must be plugged into a power source.